Search results for "Convective heat transfer"
showing 10 items of 27 documents
Using CFD to derive reduced order models for heat transfer in particle curtains
2015
3–D Eulerian–Eulerian CFD is used to simulate convective heat transfer in free falling particle curtains. Total heat loss for curtaining particles is compared to heat loss for isolated single particles. Spherical silica particles with density of 2,634 kg/m³ at 400 K (200 µm, 400 µm and 600 µm) flow at approximately 0.041 kg/s to 0.2 kg/s through a narrow slot in a rectangular box (0.45 m × 0.9 m × 0.225 m) filled with ambient air. The slot sizes through which the particles enter the rectangular box were 10 to 80 mm wide. Modifying the slot size at 0.041 kg/s for 400 µm particles can lead to 13% increases in rates of convective heat transfer per unit mass. A reduced order model was developed…
Modelling of EM glass convection
2008
PurposeTo develop the mathematical model, which allows predicting the temperature and flow distribution of an opaque glass melt with the temperature‐dependent properties in case it is generated by electromagnetic and thermal convection. Analysis has been done for geometry of the model crucible with the immersed rod electrodes. Numerical analysis is used as a tool for finding out the parameters of the system, which allow getting desiderated homogeneity of temperature field by EM action.Design/methodology/approachANSYS CFX software is implemented for coupling of EM, thermal and HD processes in the modelled system. Usability of non‐inductive approximation is shown using a full harmonic analysi…
Numerical investigation of thermomagnetic convection in a heated cylinder under the magnetic field of a solenoid
2011
The main objective of this paper is the numerical investigation of the process of thermomagnetic convection of a special temperature sensitive ferrofluid. The fluid is studied in a cylindrical domain, with constant temperatures on the top and bottom ends and adiabatic boundary conditions on the sidewalls. The thermomagnetic convection is generated by a non-uniform constant magnetic field of a solenoid, which is placed in a hollow area inside the domain. It has been found that the efficiency of convective heat transfer in such a set-up can be increased up to sevenfold by magnetic field within the studied range of parameters.
Influence of Skin Depth on Convective Heat Transfer in Induction Heating
2017
International audience; We investigate convection driven by induction heating of a horizontal fluid layer using direct numerical simulations (DNS). This problem is of particular interest in the context of nuclear severe accident mastering. In a real severe accident, the molten core is subjected to homogeneous internal sources resulting from nuclear disintegrations. This situation is mimicked in the laboratory using induction heating as the internal source. In induction heating, however, heat sources are localized in the skin layer. Consequently, this concentration of heat may modify the flow and wall heat transfer compared to the case of homogeneous internal sources. DNS are carried out for…
Heat transfer calculation in a free convection air solar collector
1998
This paper deals with the free convective air flow developing in a vertical channel with a rectangular cross-section heated on one side. The channel geometric and physical properties are such as to simulate an air solar collector suitable for building heating. A calculation method that can be applied to the transient combined heat transfer by conduction through the wall and by convection from the wall to the air stream is presented. The conduction across the wall is computed with a one-dimensional, time-dependent finite difference scheme, with convective boundary conditions at both wall surfaces. For the free convective flow along the channel, the air flow rate and the mean convective coeff…
A self-consistent 2-D model for the dip angle ofmantle downflow beneath an overriding continent
1999
Abstract We demonstrate how the inclination of descending mantle flow is affected by thepresence of a continent overriding the downwelling zone. The mantle is modelled by a fluidhaving a temperature- and pressure-dependent viscosity which describes a low viscosityasthenosphere and a higher viscosity lower mantle. The fluid occupies a square x:y=10:1 boxheated from below. In the absence of overlying continents thermal convection sets in with colddownwellings being nearly vertical. A continent is placed on the convecting mantle and starts todrift. The continent is assumed to be a thick rigid plate. We consider models of two types. Model1 involves a free-floating continent. The continent is pu…
Experimental investigations and numerical modelling of the melting process in the cold crucible
2005
PurposeAims to present recent activities in experimental investigations and numerical modelling of the induction cold crucible installation.Design/methodology/approachTemperature and velocity measurements using thermocouples and electromagnetic velocity probes were performed in aluminium melt which was used as a model melt. Measured temperature field and flow pattern were compared with transient 3D calculations based on large eddy simulation (LES) turbulence modelling scheme. Numerical results are in good coincidence with the experimental data.FindingsThe modelling results show that only 3D transient LES is able to model correctly these heat and mass transfer processes.Originality/valueIt i…
Mass transfer in nonisothermal ferrocolloids under the effect of a magnetic field
1999
Abstract The paper presents a review of newest experimental results on particle thermal diffusion in hydrocarbon based ferrofluids. The measurements are performed using a vertical thermal diffusion column, the Soret coefficient is evaluated from particle separation curves employing a simple column theory which accounts for thermal convection in the vertical channel forced by a concentration buoyancy force arising during the thermophoretic transfer of heavy particles. High positive values of the Soret coefficient of lyophilized Fe 3 O 4 and Mn x Zn 1− x Fe 2 O 4 particles in surfacted tetradecane based colloids are measured. Experiments confirm the theoretically predicted anisotropy of parti…
Thermophoretic separation of ultrafine particles in ferrofluids in thermal diffusion column under the effect of an MHD convection
2000
The aim of the paper is to evaluate the Soret coeAcient ST of colloidal particles in ferrofluids from measurements of an unsteady particle separation in a flat thermodiAusion column. The column theory is modified taking into account MHD eAects of thermal convection aAected by a concentration buoyancy force. It is shown that the Hartmann eAect, not only in hydrocarbon based colloids but also in ionic magnetic fluids of relatively high electric conductivity, does not influence significantly the particle separation dynamics. From measurements, positive values of ST of surfacted particles in tetradecane based colloids are calculated. An anisotropy of the Soret eAect in the presence of a uniform…
Effect of a finite external heat transfer coefficient on the Darcy-Bénard instability in a vertical porous cylinder
2013
Publised version of an article from the journal: Physics of Fluids. Copyright (2013) American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. Article appears in Volume 25 issue 4 of the journal: http://dx.doi.org/10.1063/1.4799253 The onset of thermal convection in a vertical porous cylinder is studied by considering the heating from below and the cooling from above as caused by external forced convection processes. These processes are parametrised through a finite Biot number, and hence through third-kind, or Robin, temperature conditions imposed on the lower and upper b…